LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 293 (Exterior Trim) >> Repair Instructions >> Rear Wheel Opening Flare Replacement

Rear Wheel Opening Flare Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Wheel Opening Flare Assembly
GM1712253Courtesy of GENERAL MOTORS CORP.
Rear Wheel Opening Flare Replacement

Callout Component Name
1 Rear Wheel Opening Flare Assembly Retainer (Qty: 4)
2 Rear Wheel Opening Flare Assembly Screw (Qty: 4)
CAUTION:

Refer to Fastener Caution .


Tighten 
2 N.m (18 lb in)
3 Rear Wheel Opening Flare Assembly
  1. The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to develop sufficient bond strength.
  2. Clean area where flare will be mounted. Use a suitable solvent, such as flash naphtha or a mix of 50 percent isopropyl alcohol and 50 percent water by volume.
  3. Warm body panel with a J-25070  Heat Gun to a minimum 21°C (70°F) prior to flare installation.
  4. Do not touch adhesive surface when tape is removed. Peel the tape liner once the flare has been installed and wet out.

Special Tools 
J-25070  Heat Gun
scientia non olet · About LEMON Manuals