Liftgate Upper Applique Replacement (GMC Yukon Two-mode Hybrid)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Liftgate Upper Applique (GMC Yukon Two-mode Hybrid)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Open and support the rear liftgate assembly. Disengage the high mounted stop lamp electrical harness grommet and connector from the rear body panel.
1	Back Body Opening Upper Applique Bolt (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten 10 N.m (89 lb in)
2	High Mounted Stop Lamp Electrical Connector
3	Retainer Pin (Qty: 3) Procedure Release the retainer pins and push upward on the rear edge of the applique. Slide the applique to the left in order to release the applique hinges from the liftgate hinge pins. Remove the applique from the vehicle.
4	Back Body Opening Upper Applique TIP: Transfer the high mounted stop assembly. Refer to High Mount Stop Lamp Replacement (Avalanche) , High Mount Stop Lamp Replacement (Yukon) , High Mount Stop Lamp Replacement (Escalade) , High Mount Stop Lamp Replacement (Yukon Two-mode Hybrid) .