Front Side Door Emblem/Nameplate Replacement (Denali)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Side Door Emblem/Nameplate (Denali)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Front Side Door Nameplate/Emblem (Denali) CAUTION: Refer to Exterior Trim Emblem Removal Caution . The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to develop sufficient bond strength. Use a J-25070 Heat Gun or equivalent to remove the old nameplate. Clean all the adhesive residue from the door and wipe the surface dry with a clean lint-free towel prior to installing new nameplate. When removing protective liners from adhesive backed nameplates, be careful not to touch the tape with hands and do not allow the tape to come in contact with dirt or any foreign matter prior to adhesion. Close the door prior to installing the new nameplate/emblem to the door. Remove the protective liner from the back side of the adhesive tape. Align the nameplate/emblem to the door and press to ensure full adhesion is made to the door. Special Tools J-25070 Heat Gun

Callout

Component Name

Front Side Door Nameplate/Emblem (Denali)

CAUTION:

Refer to Exterior Trim Emblem Removal Caution .

The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to develop sufficient bond strength.
Use a J-25070 Heat Gun or equivalent to remove the old nameplate. Clean all the adhesive residue from the door and wipe the surface dry with a clean lint-free towel prior to installing new nameplate.
When removing protective liners from adhesive backed nameplates, be careful not to touch the tape with hands and do not allow the tape to come in contact with dirt or any foreign matter prior to adhesion.
Close the door prior to installing the new nameplate/emblem to the door.
Remove the protective liner from the back side of the adhesive tape.
Align the nameplate/emblem to the door and press to ensure full adhesion is made to the door.

Special Tools
J-25070 Heat Gun