Front Fender Emblem/Nameplate Replacement (Chevrolet Tahoe Hybrid 2 Mode)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Fender Emblem/Nameplate

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Front Fender Emblem Nameplate Procedure Use a J 25070 or equivalent to remove the old emblem/nameplate. When removing protective liners from adhesive backed emblem/nameplates, be careful not to touch the tape with hands and do not allow the tape to come in contact with dirt or any foreign matter prior to adhesion. Clean all the adhesive residue from the fender using a 50/50 solution by volume of isopropyl alcohol and clean drinkable water. Wipe the surface dry with a clean lint-free towel prior to installing new emblem/nameplate. Apply palm pressure to the emblem/nameplate to ensure full adhesion is made to the fender. Special Tools J 25070 Heat Gun 500-700°F

Callout

Component Name

Front Fender Emblem Nameplate

Procedure

Use a J 25070 or equivalent to remove the old emblem/nameplate.
When removing protective liners from adhesive backed emblem/nameplates, be careful not to touch the tape with hands and do not allow the tape to come in contact with dirt or any foreign matter prior to adhesion.
Clean all the adhesive residue from the fender using a 50/50 solution by volume of isopropyl alcohol and clean drinkable water.
Wipe the surface dry with a clean lint-free towel prior to installing new emblem/nameplate.
Apply palm pressure to the emblem/nameplate to ensure full adhesion is made to the fender.

Special Tools
J 25070 Heat Gun 500-700°F