Decal or Stripe Replacement (Tahoe Hybrid 2 Mode Lower Door)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Decal Or Stripe Location

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Using a J 25070 or equivalent, in a circular motion, remove the old decal from both lower door panels. Remove all adhesives as follows: For metal body panels use a 3M Scotch Brite® molding adhesive remover disc, 3M P/N 07502 or equivalent. For plastic panels use a lint-free cloth with Varnish Makers and Painters (VMP) Naptha or a 50/50 mixture, by volume of isopropyl alcohol and clean drinkable water to remove left over adhesive. For the final preparation prior to application of the new decal, refer to Graphics/Decals/Emblems . Special Tools J 25070 Heat Gun 500-750°F
1	HYBRID Lower Door Decal TIP: The lower door decal is serviced as one part.

Callout

Component Name

Preliminary Procedures

Using a J 25070 or equivalent, in a circular motion, remove the old decal from both lower door panels.
Remove all adhesives as follows:
- For metal body panels use a 3M Scotch Brite® molding adhesive remover disc, 3M P/N 07502 or equivalent.
- For plastic panels use a lint-free cloth with Varnish Makers and Painters (VMP) Naptha or a 50/50 mixture, by volume of isopropyl alcohol and clean drinkable water to remove left over adhesive.
For the final preparation prior to application of the new decal, refer to Graphics/Decals/Emblems .

Special Tools J 25070 Heat Gun 500-750°F

HYBRID Lower Door Decal
TIP: The lower door decal is serviced as one part.