LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 293 (Exterior Trim) >> Repair Instructions >> Body Panel Paint Protector Replacement (VGC)

Body Panel Paint Protector Replacement (VGC)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. The paint protective film and vehicle surface temperature should be 13-32°C (55-90°F) for best results.
  2. Automatic car washes should be avoided for at least 24 hours after the paint protective film application.
  3. Wipe the vehicle surface with isopropyl alcohol or flash naptha at the application area.
  4. Dry the surface with a clean lint-free cloth.
  5. Create a mixture of 25 percent isopropyl alcohol and 75 percent water and two drops of baby shampoo per 16 oz. of fluid mixture.
  6. Remove the backing liner from the protective film patch.
  7. Use the solution to liberally spray the adhesive side of the protective patch, the mounting location along with your hands.
  8. Position the paint protective film patch to the desired location on the vehicle.
  9. Spray the surface of the film with the alcohol, water and soap solution.
  10. Using a dampened squeegee, start at the center of the protective patch, working outward in order to remove the air and solution from under the protective patch.
  11. Release any air bubbles with a pin.
  12. Dry the surface with a clean, lint-free cotton cloth.
scientia non olet · About LEMON Manuals