LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 293 (Exterior Trim) >> Repair Instructions >> Back Body Opening Upper Applique Replacement

Back Body Opening Upper Applique Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Back Body Opening Rear Applique
GM1672144Courtesy of GENERAL MOTORS CORP.
Back Body Opening Upper Applique Replacement

Callout Component Name
WARNING:

When a lift gate hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.
1 Rear Applique Screw (Qty: 3)
CAUTION:

Refer to Fastener Caution .


Tighten 
2 N.m (18 lb in)
  • Position the center screw to the applique first, followed by the hinge nuts second.
  • Install the outer screws last and torque the screws in the same sequence.
2 Rear Applique Nut (Qty: 2)
Tighten 
9 N.m (80 lb in)
TIP:  Disconnect the electrical connector.
3 Rear Applique
scientia non olet · About LEMON Manuals