LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Engine Controls And Fuel - 6.0L - Introduction (2 Of 2)) >> Repair Instructions >> Throttle Actuator Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: TAC Module Electrical Connectors
    GM599659Courtesy of GENERAL MOTORS CORP.
  1. Connect the TAC module electrical connectors to the TAC module.
    2. NOTE: Refer to Fastener Notice .
  2. Install the TAC module onto the studs and install the mounting nuts.

    Tighten:  Tighten the TAC mounting nuts to 9 N.m (80 lb in).

  3. Install the left hand corner brace.

    Tighten:  Tighten the corner brace bolts to 25 N.m (18 lb ft).

  4. Refer to Control Module References for programming and setup information.
scientia non olet · About LEMON Manuals