LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Engine Controls And Fuel - 6.0L - Introduction (2 Of 2)) >> Repair Instructions >> Spark Plug Wire Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Spark Plug Wire & Boot
    GM343699Courtesy of GENERAL MOTORS CORP.
  1. Install the spark plug wires at the ignition coil.
  2. Install the spark plug wire to each spark plug.
  3. Inspect the wires for proper installation:
    • Push sideways on each boot in order to inspect the seating.
    • Reinstall any loose boot.
scientia non olet · About LEMON Manuals