Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Blowing Dirt Out Of Fitting (Plastic Collar)

Courtesy of GENERAL MOTORS CORP.

Relieve the fuel system pressure before servicing any fuel system connection. Refer to Fuel Pressure Relief .

CAUTION: Wear safety glasses when using compressed air in order to prevent eye injury.

Using compressed air, blow any dirt out of the quick-connect fitting.

Fig 2: Squeezing Quick Connect Fitting Release Tabs (Plastic Collar)

Courtesy of GENERAL MOTORS CORP.

Squeeze the plastic retainer release tabs.

Fig 3: Pulling Connection Apart (Plastic Collar)

Courtesy of GENERAL MOTORS CORP.

Pull the connection apart.