LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Engine Controls And Fuel - 6.0L - Introduction (2 Of 2)) >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Lightly coat the MAP sensor seal with clean engine oil before installing the sensor.
    Fig 1: View Of Manifold Absolute Pressure (MAP) Sensor
    GM863068Courtesy of GENERAL MOTORS CORP.
  1. Install the MAP sensor (1). Push the MAP sensor down in order to engage the sensor into the retainer.
    2. Fig 2: View Of Top Engine Cover
    GM665886Courtesy of GENERAL MOTORS CORP.
  2. Connect the MAP sensor electrical connector.
  3. Position the engine harness and sight shield bracket to the intake manifold.
    4. NOTE: Refer to Fastener Notice .
  4. Install the engine sight shield bracket bolts.

    Tighten:  Tighten the bracket bolts to 10 N.m (89 lb in).

  5. Install the engine sight shield. Refer to Upper Intake Manifold Sight Shield Replacement (6.0L (LQ4)) .
scientia non olet · About LEMON Manuals