LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Engine Controls And Fuel - 6.0L - Introduction (2 Of 2)) >> Repair Instructions >> Knock Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Knock Sensor Wiring Harness Assembly
    GM54608Courtesy of GENERAL MOTORS CORP.
  1. Remove the intake manifold. Refer to Intake Manifold Replacement .
  2. Remove the knock sensor wiring harness assembly.
    3. Fig 2: Identifying Knock Sensors
    GM54612Courtesy of GENERAL MOTORS CORP.
  3. Remove the knock sensor (KS).
scientia non olet · About LEMON Manuals