LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Engine Controls And Fuel - 6.0L - Introduction (2 Of 2)) >> Repair Instructions >> Heated Oxygen Sensor Replacement - Bank 2 Sensor 2 >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to Vehicle Lifting Caution .
  1. Raise the vehicle.
    2. Fig 1: Locating O2 Sensor
    GM715480Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Heated Oxygen and Oxygen Sensor Notice .
  2. Disconnect the connector (1) for the HO2S.
    3. NOTE: Refer to Excessive Force and Oxygen Sensor Notice .
  3. Remove the HO2S (2) using a J 39194-B  . See Special Tools .
scientia non olet · About LEMON Manuals