LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Engine Controls And Fuel - 6.0L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Tank Filler Hose Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean all the fuel pipe and hose connections and the surrounding areas before disconnecting in order to avoid possible contamination of the fuel system.
  2. Drain the fuel below the level of the filler tube and hose assembly. Refer to Fuel Tank Draining .
  3. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
    4. Fig 1: Fuel Fill Hose & Hose Clamps
    GM832912Courtesy of GENERAL MOTORS CORP.
  4. Loosen the fuel fill hose clamp at the fuel tank.
  5. Loosen the fuel fill hose clamp at the fuel fill pipe.
  6. Remove the fuel fill hose and the hose clamps.
  7. Cap the fuel tank opening.
scientia non olet · About LEMON Manuals