LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Engine Controls And Fuel - 6.0L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Tank Filler Hose Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Fuel Fill Hose & Hose Clamps
    GM832912Courtesy of GENERAL MOTORS CORP.
  1. Uncap the fuel tank opening.
    2. NOTE: Refer to Fastener Notice .
  2. Install the fuel fill hose and the hose clamps to the fuel fill pipe.

    Tighten:  Tighten the hose clamps to 2.5 N.m (22 lb in).

  3. Lower the vehicle.
  4. Refill the fuel system.
scientia non olet · About LEMON Manuals