LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Engine Controls And Fuel - 6.0L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Hose/Pipes Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Fuel Sender & Fuel Pressure Sensor Electrical Connectors
    GM863091Courtesy of GENERAL MOTORS CORP.
  1. Remove the caps from the fuel pipes.
  2. Connect the rear fuel feed pipe and the rear fuel return pipe to the fuel sender and the fuel tank clips.
  3. Install the fuel tank. Refer to Fuel Tank Replacement .
scientia non olet · About LEMON Manuals