LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Engine Controls And Fuel - 6.0L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission System Hoses/Pipes Replacement (Rear EVAP Fuel Tank Pipe) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the caps from the fuel sender EVAP pipe and the fuel tank roll over valve.
  2. Connect the rear EVAP pipe to the fuel sender, the fuel tank roll over valve, and the fuel tank clips.
    3. Fig 1: Fuel Tank Straps & Attaching Bolts
    GM863085Courtesy of GENERAL MOTORS CORP.
  3. Install the fuel tank. Refer to Fuel Tank Replacement .
  4. Lower the vehicle.
  5. Refill the fuel tank.
  6. Connect the negative battery cable.
  7. Tighten the fuel filler cap.
  8. Inspect for leaks.
    1. Turn ON the ignition for 2 seconds.
    2. Turn OFF the ignition for 10 seconds.
    3. Turn ON the ignition.
    4. Inspect for fuel leaks.
scientia non olet · About LEMON Manuals