LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Engine Controls And Fuel - 6.0L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission System Hoses/Pipes Replacement (Engine Compartment EVAP Pipe) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of EVAP Purge Solenoid Vent Tube
    GM372717Courtesy of GENERAL MOTORS CORP.
  1. Remove the caps from the EVAP canister purge solenoid and the chassis EVAP pipe.
  2. Install the EVAP pipe on the engine.
  3. Connect the engine compartment EVAP pipe (3) to the chassis EVAP pipe.
  4. Connect the engine compartment EVAP pipe (2) to the EVAP canister purge solenoid (1).
scientia non olet · About LEMON Manuals