LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Engine Controls And Fuel - 6.0L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission System Hoses/Pipes Replacement (EVAP Vent Pipe) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: EVAP Vent Pipe & Mounting Clips
    GM627206Courtesy of GENERAL MOTORS CORP.
  1. Remove the caps from the EVAP vent valve and the EVAP canister.
  2. Connect the EVAP vent pipe (2) to the EVAP vent valve.
  3. Connect the EVAP vent pipe to the EVAP canister.
  4. Install the EVAP vent pipe into the mounting clips (1,3,4, and 5).
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals