LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Engine Controls And Fuel - 6.0L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission System Hoses/Pipes Replacement (Chassis EVAP Pipe) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the EVAP pipe into the retaining clips.
    2. Fig 1: Vent Pipe & EVAP Canister Vent Valve Electrical Connector
    GM832914Courtesy of GENERAL MOTORS CORP.
  2. Remove the cap from the rear EVAP pipe.
  3. Connect the rear EVAP purge pipe to the EVAP canister.
    4. Fig 2: View Of Rear Of Engine Fuel Pipe Connections
    GM300360Courtesy of GENERAL MOTORS CORP.
  4. Install the EVAP pipe into the transmission bracket clip.
  5. Install the EVAP pipe into the bellhousing stud clip (4).
  6. Install the left hand catalytic converter. Refer to Catalytic Converter Replacement (4.8L and 5.3L Engines) .
  7. Lower the vehicle.
  8. Remove the cap from the engine compartment EVAP pipe.
  9. Connect the engine compartment EVAP pipe (6) to the chassis EVAP pipe (3).
scientia non olet · About LEMON Manuals