LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Engine Controls And Fuel - 6.0L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Vent Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Vent Pipe & EVAP Canister Vent Valve Electrical Connector
    GM832914Courtesy of GENERAL MOTORS CORP.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the vent pipe from the evaporative emission (EVAP) canister vent valve.
  3. Disconnect the EVAP canister vent valve electrical connector.
  4. Detach the EVAP canister vent valve from the EVAP canister vent valve bracket.
scientia non olet · About LEMON Manuals