LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Engine Controls And Fuel - 6.0L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Vent Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Vent Pipe & EVAP Canister Vent Valve Electrical Connector
    GM832914Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP canister vent valve to the EVAP canister vent valve bracket.
  2. Connect the EVAP canister vent valve electrical connector.
  3. Connect the vent pipe to the EVAP canister vent valve.
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals