LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Engine Controls And Fuel - 6.0L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Chassis Fuel Feed Hose & Fuel Filter
    GM832909Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP canister to the vehicle.
  2. Connect EVAP solenoid electrical connector.
    3. NOTE: Refer to Fastener Notice .
  3. Install the EVAP canister mounting bolts.

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

    4. Fig 2: Vent Pipe & EVAP Canister Vent Valve Electrical Connector
    GM832914Courtesy of GENERAL MOTORS CORP.
  4. Connect the pipes to the EVAP canister.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals