LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Engine Controls And Fuel - 6.0L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Purge Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Top Engine Cover
    GM665886Courtesy of GENERAL MOTORS CORP.
  1. Remove the engine sight shield. Refer to Upper Intake Manifold Sight Shield Replacement (6.0L (LQ4)) .
    2. Fig 2: View Of EVAP Pipe Quick Connect Fitting
    GM344610Courtesy of GENERAL MOTORS CORP.
  2. Push the evaporative emission (EVAP) pipe quick connect fitting retainer inward.
    3. Fig 3: View Of EVAP Purge Solenoid Vent Tube
    GM372717Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the EVAP pipe (2) from the EVAP purge solenoid (1).
    4. Fig 4: View Of EVAP Purge Solenoid Bolt, Solenoid & Isolator
    GM389993Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the EVAP purge solenoid electrical connector.
  5. Remove the EVAP purge solenoid mount bolt (2).
  6. Remove the EVAP purge solenoid (3) and the insulator (1) from the engine.
scientia non olet · About LEMON Manuals