LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Engine Controls And Fuel - 6.0L - Introduction (2 Of 2)) >> Repair Instructions >> Air Cleaner Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: MAF/IAT Sensor & Air Cleaner Assembly
    GM832908Courtesy of GENERAL MOTORS CORP.
  1. Remove the air intake duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
  2. Disconnect the mass air flow/intake air temperature (MAF/IAT) sensor connector.
  3. Loosen the clamp securing the MAF/IAT sensor to the air cleaner assembly.
  4. Remove the MAF/IAT sensor.
    5. Fig 2: Air Cleaner Assembly
    GM832916Courtesy of GENERAL MOTORS CORP.
  5. Remove the air cleaner housing fasteners.
  6. Remove the air cleaner assembly.
scientia non olet · About LEMON Manuals