LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Front Drive Axle) >> Repair Instructions >> Vent Hose Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the front differential carrier shield, if equipped. Refer to Engine Protection Shield Replacement .
    3. IMPORTANT: Make note of the routing in order to aid in reassembly.
  3. Remove the vent hose (1) from the wiring bundle.
  4. Remove the vent hose from the clip.
    5. Fig 1: Identifying Vent Hose & Differential Carrier Case Assembly
    GM865993Courtesy of GENERAL MOTORS CORP.
  5. Remove the vent hose (1) from the differential carrier case assembly (2).
  6. Remove the vent hose (1) from the vehicle.
scientia non olet · About LEMON Manuals