Installation Procedure
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
- Install the vent hose (1) to the vehicle.
- Route the vent hose the same way as when removed.
- Ensure the hose is free of kinks and routes clear of sharp components.
- Ensure the vent hose is not plugged.
- Connect the vent hose (1) to the differential carrier case assembly (2).
- Install the vent hose (1) to the wiring bundle.
- Install the vent hose to the clip.
- Install the front differential carrier shield, if equipped. Refer to Engine Protection Shield Replacement .
- Lower the vehicle.