LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Front Drive Axle) >> Repair Instructions >> Vent Hose Connector Replacement - Front Drive Axle >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer Lifting and Jacking the Vehicle .
  2. Remove the engine protection shield. Refer to Engine Protection Shield Replacement .
    3. Fig 1: Front Drive Axle Vent Hose & Vent Hose Connector
    GM1335147Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the vent hose from the vent hose connector.
    4. Fig 2: Front Drive Axle Vent Hose Connector
    GM1335150Courtesy of GENERAL MOTORS CORP.
  4. Remove the vent hose connector.
scientia non olet · About LEMON Manuals