LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Front Drive Axle) >> Repair Instructions >> Vent Hose Connector Replacement - Front Drive Axle >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Front Drive Axle Vent Hose Connector
    GM1335150Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the vent hose connector.

    Tighten:  Tighten the vent hose connector to 20 N.m (15 lb ft).

    2. Fig 2: Front Drive Axle Vent Hose & Vent Hose Connector
    GM1335147Courtesy of GENERAL MOTORS CORP.
  2. Connect the vent hose to the vent hose connector.
  3. Install the engine protection shield. Refer to Engine Protection Shield Replacement .
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals