Lubricant Level Inspection - Front Drive Axle
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
- Make sure the vehicle is level.
- Inspect the front axle for leaks. Repair as necessary.
- Remove the engine protection shield (if equipped). Refer to Engine Protection Shield Replacement .
- Clean the area around the front axle fill plug (1).
- Remove the front axle fill plug (1).
- Inspect the oil level.
Specification: The oil level should be between 0-10 mm (0-0.375 in) below the fill plug opening.
- If the level is low, add oil until the level is even with the bottom edge of the fill plug opening. Use the proper fluid. Refer to Fluid and Lubricant Recommendations .
- Install the fill plug.
Tighten: Tighten the plug to 33 N.m (24 lb ft).
- Install the engine protection shield. Refer to Engine Protection Shield Replacement .
- Lower the vehicle.
NOTE:
Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.