LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Front Drive Axle) >> Repair Instructions >> Differential Carrier Assembly Bushing Replacement (Inner Axle Shaft Housing) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the inner shaft housing. Refer to Inner Shaft and/or Housing Replacement - Front Drive Axle .
  2. Install the inner shaft housing into a vise.
    3. Fig 1: Installing J 45755-2, J 45755-1, Forcing Screw, Bearing & Washers Over Inner Shaft Housing Bushing
    GM863546Courtesy of GENERAL MOTORS CORP.
  3. Install the J 45755-2 (2), J 45755-1 (1), and the forcing screw, bearing and washers (3) over the inner shaft housing bushing as shown.
  4. Remove the inner shaft housing bushing using the J 45755  . See Special Tools .
scientia non olet · About LEMON Manuals