LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Front Drive Axle) >> Repair Instructions >> Differential Carrier Assembly Bushing Replacement (Differential Carrier) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the differential carrier assembly. It is not necessary to drain the differential carrier assembly. Seal the vent tube opening with a piece of tape to prevent the axle lubricant from leaking from the differential carrier assembly. Refer to Differential Carrier Assembly Replacement .
    2. Fig 1: Installing J 45755-3, J 45755-4, Forcing Screw, Bearing & Washers Over Differential Carrier Assembly
    GM863549Courtesy of GENERAL MOTORS CORP.
  2. Install the J 45755-3 (2), J 45755-4 (3), and the forcing screw, bearing and the washers (1) over the differential carrier assembly bushing as shown.
  3. Remove the differential carrier assembly bushing using the J 45755  . See Special Tools .
scientia non olet · About LEMON Manuals