LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Front Drive Axle) >> Repair Instructions >> Differential Carrier Assembly Bushing Replacement (Differential Carrier) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the differential carrier assembly bushing into the differential carrier assembly bushing bore.
    2. Fig 1: Installing J 45755-2, J 45755-1, Forcing Screw, Bearing & Washers Over Differential Carrier Assembly Bushing
    GM863551Courtesy of GENERAL MOTORS CORP.
  2. Install the J 45755-2 (2), J 45755-1 (3), and the forcing screw, bearing and washers (1) over the differential carrier assembly bushing as shown.
  3. Press the bushing into the differential carrier assembly bushing bore using the J 45755  . See Special Tools .
  4. Install the differential carrier assembly. Once the differential carrier assembly is installed, remove the piece of tape in order to connect the vent hose. Refer to Differential Carrier Assembly Replacement .
scientia non olet · About LEMON Manuals