LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 270 (Engine Mechanical - 4.8L, 5.3L, 6.0L Or 6.2L (3 Of 5)) >> On-Vehicle Repair Instructions (2 Of 2) >> Oil Pump, Screen & Crankshaft Oil Deflector Replacement (RPOs LY6/L76/L92) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Pump Screen Tube, Bolt & Nuts
    GM647800Courtesy of GENERAL MOTORS CORP.
  1. Remove the oil pan. Refer to Oil Pan Replacement (2WD) or Oil Pan Replacement (4WD) .
  2. Remove the engine front cover. Refer to Engine Front Cover Replacement (LC9, LH6, LMG, LY2 and LY5) or Engine Front Cover Replacement (LY6, L76 and L92) .
  3. Remove the oil pump screen bolt and nuts.
  4. Remove the oil pump screen with O-ring seal.
  5. Remove the O-ring seal from the pump screen.
  6. Discard the O-ring seal.
    7. Fig 2: View Of Crankshaft Oil Deflector & Nuts
    GM683798Courtesy of GENERAL MOTORS CORP.
  7. Remove the remaining crankshaft oil deflector nuts.
  8. Remove the crankshaft oil deflector.
    9. Fig 3: View Of Oil Pump & Bolts
    GM1658173Courtesy of GENERAL MOTORS CORP.
  9. Remove the oil pump bolts (411).
    10. IMPORTANT: Do not allow dirt or debris to enter the oil pump assembly, cap end as necessary.
  10. Remove the oil pump (413)
scientia non olet · About LEMON Manuals