LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Mirrors) >> Repair Instructions >> Outside Rearview Mirror Glass Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the mirror face on a angle to the mirror housing.
    Fig 1: Outside Rearview Mirror Installation Procedure
    GM1990756Courtesy of GENERAL MOTORS CORP.
  2. Install the mirror face as follows:
    1. Holding the mirror face, connect the electrical connectors to the back of the mirror.
    2. Position the mirror face to the motor retainer tabs.
    3. Position the hand in the center of the mirror face.
    4. Apply light pressure to the face.
    5. Push downward and inward to lock in place.
    6. Inspect the mirror face for proper operation.
scientia non olet · About LEMON Manuals