Stabilizer Shaft Link Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Stabilizer Shaft Link

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
1	Rear Upper Stabilizer Shaft Link Nut NOTE: Refer to Fastener Notice . Tighten: 75 N.m (55 lb ft)
2	Rear Upper Stabilizer Shaft Link Bolt
3	Rear Lower Stabilizer Shaft Nut (Qty: 2) Procedure Use an Allen wrench to keep the lower stabilizer shaft ball stud from rotating while removing the outer nut. When installing the inner stabilizer shaft link nut, ensure that it is tighten securely against the ball joint. Tighten: 75 N.m (55 lb ft)
4	Rear Stabilizer Shaft