LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 267 (Steering Linkage) >> Repair Instructions >> Steering Linkage Inner Tie Rod Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine shield, if equipped. Refer to Engine Shield Replacement .
  2. Remove the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement .
    3. Fig 1: View Of Inner Tie Rod End & J 34028
    GM865341Courtesy of GENERAL MOTORS CORP.
  3. Remove the steering linkage inner tie rod (1) from the relay rod using wrench J 34028  (2). See Special Tools .
scientia non olet · About LEMON Manuals