LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 267 (Steering Linkage) >> Repair Instructions >> Steering Linkage Inner Tie Rod Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove all traces of oil, grease, or other contaminants.
  2. Clean the threads of the steering linkage inner tie rod with denatured alcohol or the equivalent and allow to dry.
  3. Apply red LOCTITE™ threadlocker, GM P/N 12345493 (Canadian P/N 10953488) to the threads of the steering linkage inner tie rod.
    4. Fig 1: View Of Inner Tie Rod End & J 34028
    GM865341Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  4. Install the steering linkage inner tie rod (1) to the relay rod using wrench J 34028  (2). See Special Tools .

    Tighten:  Tighten the steering linkage inner tie rod to 100 N.m (74 lb ft).

  5. Install the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement .
  6. Install the engine shield, if equipped. Refer to Engine Shield Replacement .
  7. Adjust the front toe. Refer to Front Toe Adjustment .
scientia non olet · About LEMON Manuals