LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 267 (Steering Linkage) >> Repair Instructions >> Pitman Arm Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering gear. Refer to Steering Gear Replacement (Rack and Pinion) or Steering Gear Replacement (Non-Rack and Pinion) or Steering Gear Replacement (Two Mode Hybrid) .
  2. Place the steering gear into a vise.
    3. Fig 1: View Of Steering Gear & Pitman Arm
    GM1862648Courtesy of GENERAL MOTORS CORP.
  3. Remove the pitman arm nut (1) and washer (2).
    4. Fig 2: View Of Pitman Arm, Power Steering Gear (Non Rack and Pinion) & Special Tools
    GM398243Courtesy of GENERAL MOTORS CORP.
  4. Remove the pitman arm from the pitman arm shaft using puller J 6632-01  or puller J 29107-A  . See Special Tools .
scientia non olet · About LEMON Manuals