LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 267 (Steering Linkage) >> Repair Instructions >> Idler Arm Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Do not attempt to free the ball stud by using a pickle fork or wedge type tool, because seal or bushing damage could result. Use the proper tool to separate all ball joints.
  1. Remove the engine shield, if equipped. Refer to Engine Shield Replacement .
    2. Fig 1: View Of Idler Arm & Relay Rod
    GM1862657Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Discard the idler arm nut.
  2. Remove the idler arm nut (3) from the idler arm (1).
  3. Separate the idler arm (1) from the relay rod (2).
    4. Fig 2: View Of Outer Tie Rod Assembly & J 24319-B
    GM643351Courtesy of GENERAL MOTORS CORP.
  4. Remove the idler arm from the relay rod using puller J 24319-B  .
    5. Fig 3: View Of Idler Arm, Frame Bolts & Nuts
    GM340442Courtesy of GENERAL MOTORS CORP.
  5. Remove the idler arm bolts (3) and the nuts (1) at the vehicle frame.
  6. Remove the idler arm (2) from the vehicle.
scientia non olet · About LEMON Manuals