LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 266 (Transfer Case - BW 4485-Nr3) >> Repair Instructions - On Vehicle >> Transfer Case Fluid Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Cadillac Escalade EXT, 2008 Cadillac Escalade ESV, and 2008 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: When performing the following procedure, use only hand tools to remove and install the drain and fill plugs.
    Fig 1: View Of Transfer Case Fill Plug
    GM660281Courtesy of GENERAL MOTORS CORP.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
  3. Remove the fill plug.
    4. Fig 2: View Of Transfer Case Drain Plug
    GM823193Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure that an approved drain pan is used when draining the transfer case.
  4. Remove the drain plug.
  5. Allow the transfer case to drain completely.
scientia non olet · About LEMON Manuals