LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 266 (Transfer Case - BW 4485-Nr3) >> Repair Instructions - On Vehicle >> Rear Output Shaft Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Cadillac Escalade EXT, 2008 Cadillac Escalade ESV, and 2008 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Front Output Shaft Seal Installation Special Tool
    GM1728916Courtesy of GENERAL MOTORS CORP.
  1. Using the J 45756  , install a NEW front output shaft seal. See Special Tools .
  2. Install the rear propeller shaft. Refer to Rear Propeller Shaft Replacement .
  3. Check the fluid level. Add fluid, if necessary.
  4. Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals