LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 266 (Transfer Case - BW 4485-Nr3) >> Repair Instructions - On Vehicle >> Front Output Shaft Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Cadillac Escalade EXT, 2008 Cadillac Escalade ESV, and 2008 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Seal Installation Special Tools
    GM1728904Courtesy of GENERAL MOTORS CORP.
  1. Install the J 43484  (2) to the J 8092  (1). See Special Tools .
  2. Install a NEW seal onto J 43484  . See Special Tools .
  3. Using J 43484  (2), and J 8092  (1), install the seal. See Special Tools .
  4. Install the front propeller shaft. Refer to Front Propeller Shaft Replacement .
  5. Check the fluid level. Add fluid, if necessary.
  6. Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals