LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 266 (Transfer Case - BW 4485-Nr3) >> Repair Instructions - Off Vehicle >> Transfer Case Cleaning and Inspection >> Front Output Shaft

Front Output Shaft

WARNING: This page is about a different car, the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Cadillac Escalade EXT, 2008 Cadillac Escalade ESV, and 2008 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Front Output Shaft
    GM819682Courtesy of GENERAL MOTORS CORP.
  1. Clean the front output shaft in cleaning solvent and air dry.
  2. Inspect for spun bearings at the front output shaft bearing areas.
  3. Inspect the front output internal splines and driven gear splines for damage or excessive wear.
  4. Replace the front output shaft if it is damaged.
  5. Inspect the cup plug in the front output shaft for leaking.
  6. Replace the cup plug if it is leaking. Refer to Transfer Case Disassemble  and Transfer Case Assemble .
scientia non olet · About LEMON Manuals