LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 263 (Engine Mechanical - Hybrid (Hp2) 6.0L (LFA)) >> Repair Instructions - On Vehicle >> Upper Intake Manifold Cover Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Upper Intake Manifold Cover & Nut
    GM1697057Courtesy of GENERAL MOTORS CORP.
  1. Install the upper intake manifold cover.
  2. Install the upper intake manifold cover nut until snug
    3. Fig 2: View Of Vacuum Brake Booster Hose
    GM1697051Courtesy of GENERAL MOTORS CORP.
  3. Install the brake booster vacuum hose to the intake manifold nipple.
  4. Position the brake booster vacuum hose clamp at the intake manifold.
  5. Install the intake manifold. Refer to Intake Manifold Replacement .
scientia non olet · About LEMON Manuals