LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 263 (Engine Mechanical - Hybrid (Hp2) 6.0L (LFA)) >> Repair Instructions - On Vehicle >> Engine Oil Pressure Sensor and/or Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Harness Electrical Connectors & Inlet Hose Clamp
    GM1697098Courtesy of GENERAL MOTORS CORP.
  1. Remove the intake manifold. Refer to Intake Manifold Replacement .
  2. Disconnect the engine harness electrical connector (1) from the oil pressure sensor.
    3. Fig 2: View Of Oil Pressure Sensor, Washer And Valve Lifter Oil Filter
    GM1402008Courtesy of GENERAL MOTORS CORP.
  3. Using the J 41712  or equivalent, remove the oil pressure sensor (706) and washer (707).
scientia non olet · About LEMON Manuals