Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Oil Pressure Sensor, Washer And Valve Lifter Oil Filter

Courtesy of GENERAL MOTORS CORP.

Apply sealant to the threads of the NEW oil pressure sensor. Refer to Adhesives, Fluids, Lubricants, and Sealers .

NOTE: Refer to Fastener Notice .

Using J 41712 or equivalent, install the oil pressure sensor (706) and washer (707).
Tighten: Tighten the sensor to 35 N.m (26 lb ft).

Fig 2: View Of Engine Harness Electrical Connectors & Inlet Hose Clamp

Courtesy of GENERAL MOTORS CORP.

Connect the engine harness electrical connector (1) to the oil pressure sensor.
Tighten: Tighten the sensor to 35 N.m (26 lb ft).
Install the intake manifold. Refer to Intake Manifold Replacement .