LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 263 (Engine Mechanical - Hybrid (Hp2) 6.0L (LFA)) >> Repair Instructions - On Vehicle >> Engine Oil Level Sensor and/or Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Pan Drain Plug & Seal
    GM1658109Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Place a suitable drain pan under the oil pan drain plug.
  3. Remove the oil pan drain plug (430).
  4. Allow the oil pan to drain completely.
  5. Re-install the oil pan drain plug until snug.
  6. Remove the drain pan from under the vehicle.
    7. Fig 2: Identifying Engine Harness Electrical Connector & Oil Level Sensor
    GM1968647Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the engine harness electrical connector (1) from the oil level sensor.
    8. Fig 3: View Of Oil Level Sensor
    GM260123Courtesy of GENERAL MOTORS CORP.
  8. Remove the oil level sensor from the oil pan.
scientia non olet · About LEMON Manuals