LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 263 (Engine Mechanical - Hybrid (Hp2) 6.0L (LFA)) >> Repair Instructions - On Vehicle >> Drive Belt Tensioner Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Drive Belt Tensioner
    GM1959995Courtesy of GENERAL MOTORS CORP.
  1. Install the drive belt tensioner (2).
  2. Install the drive belt tensioner bolts (1).
    NOTE: Refer to Fastener Notice.
  3. Tighten the drive belt tensioner bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  4. Install the drive belt. Refer to Drive Belt Replacement .
scientia non olet · About LEMON Manuals