LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 263 (Engine Mechanical - Hybrid (Hp2) 6.0L (LFA)) >> Repair Instructions - On Vehicle >> Drive Belt Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Drive Belt And Drive Belt Tensioner
    GM1959725Courtesy of GENERAL MOTORS CORP.
  1. Remove the air cleaner resonator outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
  2. Install a breaker bar with hex-head socket to the drive belt tensioner bolt.
  3. Rotate the drive belt tensioner clockwise in order to relieve tension on the belt.
  4. Remove the belt (1) from the pulleys and the drive belt tensioner (2).
  5. Slowly release the tension on the drive belt tensioner.
  6. Remove the breaker bar and socket from the drive belt tensioner bolt.
  7. Clean and inspect the belt surfaces of all the pulleys.
scientia non olet · About LEMON Manuals